Trimans Variable Rake Angle NC Hydraulic Shears

NuGEN manufacturers Trimans Variable Rake Angle NC Hydraulic shearing machines built as per international standards in a range of 4 mm to 16 mm sheet thickness and length of 1500 mms. to 5000 mms.

Two Hydraulic cylinders mounted on the cutting beam provide the shearing force. Synchronizing of the two cylinders by differential area principle simplifies the hydraulic circuit.

The rake angle of shearing blade can be adjusted by a selector switch on the Panel Box. This enables cutting of higher thickness than nominal capacity at the same time facilitating twist-free shearing of thin sheets, when used as per IMTMA standards.

Three pre-loaded roller system guide the cutting beam accurately on both sides at an angle of 1-1.5 degree to the vertical to avoid the non-cutting edges of the blade from rubbing against the sheet and avoid trapping of cut sheets between the bottom blade and back gauge.

All four sides of top and bottom HCHCr blades are usable reducing regrinding and part replacement.

The easiest and fastest blade clearance arrangement is offered on this range of shears. The blade clearance is calibrated for different thickness and can be accurately set by lever. The Hydraulic hold downs are located very close to the blade and provide positive gripping of sheets enabling distortion-free shearing of narrow strips.

Independent control of hold downs facilitates shearing on scribed lines. The shear automatically returns on completion of the cut irrespective of job length, reducing the idle travel.

Trimans HVR Series are offered as standard execution with Main Drive Motor, Electrical Control Panel, Operational Console, Foot Switch, Motorized Back Gauge with digital readout, Pre-selected selector Switch controlled variable rake angle system, Fine stroke adjustment with calibration, Hold-down cylinders, Shadow line indicators, Front sheet supports, Left squaring arm with steel rule, Four edge HcHCr Blade, Hardened Transfer Bars etc.

Above all the machines are totally lubrication free.

Also available are Trimans Fixed Rake Angle Hydraulic shears (FR Series) in range of thickness 2 mms. to 10 mms. & in a length of 1500 mm to 3000 mm and Trimans Extra Edge Hydraulic shears (EE Series) in a range of 20 mm, 25 mm and 32 mm and length of 3000 mm to 5000 mm.

17, Changodar Ind. Estate,
Sharkhej-Bawla Highway,
Town : Changodar – 382 213.
Ta. Sanand, Dist. Ahmedabad

Tel       :- +91-2717-250380 / 250963 / 250964
Fax      :- +91-2717-250310
E-mail  :- info@nugenindia.com
Web     :- www.nugenindia.com